Search found 5 matches

Go to advanced search

by nJed
Fri Jan 24, 2020 7:31 pm
Forum: Hardware Discussions
Topic: Looking for advice / recommendations on laser CNC
Replies: 3
Views: 1040

Re: Looking for advice / recommendations on laser CNC

Thanks for the reply, John. Not at all too negative. I've been doing some reading on the diode lasers and the consensus seems to agree with your statements regarding claims of anything over 7W as well as the inability to cut 1/4 ply in a single pass. As I said originally, the cutting was only a 'nic...
by nJed
Fri Jan 24, 2020 12:37 pm
Forum: Hardware Discussions
Topic: Looking for advice / recommendations on laser CNC
Replies: 3
Views: 1040

Looking for advice / recommendations on laser CNC

Hi folks: I'm looking for feedback on a new laser system. Currently I'm running an Emblaser 1 - which serves my needs fairly well. I'm looking to expand my capabilities with a larger system and I'm looking for feedback. Ideally I would like to have a working area in the range of 36" square or s...
by nJed
Sat Jun 30, 2018 5:58 pm
Forum: PicSender
Topic: Pause in the middle of nc file
Replies: 2
Views: 2027

Re: Pause in the middle of nc file

Thanks Jeff. I am using a vector gcode file from CUT2D.....I'll check the settings and give the new version a try.

I appreciate the feedback.

-Ed
by nJed
Sat Jun 30, 2018 3:14 pm
Forum: PicSender
Topic: Pause in the middle of nc file
Replies: 2
Views: 2027

Pause in the middle of nc file

Good Day: I'm having a small issue using picsender (2.7.6). I have a relatively small nc file that engraves in approx ten minutes. Slightly more than half way thru the project the laser engraver (emblaser) pauses for a few seconds with the laser staying @ full power resulting in a noticeable extra b...
by nJed
Wed Apr 26, 2017 12:28 pm
Forum: PicEngrave Pro 5 or 6
Topic: Starting settings for a monochrome bitmap
Replies: 1
Views: 2311

Starting settings for a monochrome bitmap

Good Day: I have typically engraved vector paths with my engraver (an 'emblaser') but have a need to engrave some bitmap images. The original artwork is a monochrome bitmap @ 300dpi - I was hoping to get some suggestions regarding initial settings to try. I'm curious, since the image is B&W, whe...

Go to advanced search

cron