again, TY TY TY for help/suggestions
attached is settings from pep5
which setting should i be using for pwm?
the laser specs attached as imagehttp://www.ebay.com/itm/12W-Laser-Head- ... SwayZXj0zV
i am using certified Uno3 328p from arduino.cc
i am using V3 of prontoneer which i need to switch connections depending on version of grbl for pwm and Z-stop. (designed for grbl 0.8)
could that have any effect on control?
i looked at the synthetos board and will most likely get one shortly.
i tried the 45 print without success.
the vertical is printing now and seems to be doing good...so far. i will post reply with pass/fail on print