Page 2 of 2

Re: PicSender v3 Update Released

Posted: Wed Dec 18, 2019 10:54 pm
by hamprich1023
I just downloaded the newest ver. but I keep getting an alarm when I use the goto command on the Y axis. Its popped 3 different errors. 1. A limit switch is tripped when not near any limit switch. 2. Its exceeded its axis limit when its not near any axis ( never seen this error notice before) 3. It will say it triggered an alarm but then still keep crawling at maybe 5 ipm. When I revert back to earlier Ver.'s the errors dont happen anymore. This only happens on the Y-Axis.

Re: PicSender v3 Update Released

Posted: Thu Dec 19, 2019 8:50 am
by Picengraver
There is an issue that has affected some system configurations. The latest update has been temporarily withdrawn as this is resolved. It should be fixed and a new update released soon. Please check back in a couple of days. We apologize for the problem.
John Champlain