Page 2 of 2

Re: Feed Rate problems with GRBL + Piclaser

Posted: Wed Jan 06, 2016 10:07 am
by comeollas
I found the problem, now i d'ont know if the problem is GRBL 0.9J or not but i changed GRBL controller for send gcode for UGS (universal gcode sender) and it works now!!

Thanks your time Picengravertoo and patience :oops: maybe this post can help to another ppl with same problems.

Re: Feed Rate problems with GRBL + Piclaser

Posted: Wed Jan 06, 2016 10:20 am
by Picengravertoo
Ok, not if, but when UGS scraps out your laser photo engraving project mid stream, take a look at our PicSender streamer. It's been tested to stream 10,000,000+ lines of raster gcode reliably. ;)

viewtopic.php?f=10&t=125

http://www.picengrave.com/PicSender.htm

Re: Feed Rate problems with GRBL + Piclaser

Posted: Wed Jan 06, 2016 12:13 pm
by comeollas
I changed GRBL Cotroller for Universal Gcode Sender and now works good!

Now i can started to make tests with your test image and i see some ghosting but this is another thing jejejeje

Thanks picengravertoo! I start to make some engravings and post it.