Page 1 of 1

Memorial

Posted: Sun Dec 27, 2015 9:54 am
by Honk
puma.jpg
puma.jpg (133.62 KiB) Viewed 4011 times

I am having a problem with my Z axis moving to slow. leaving dark lines on areas of large moves.(around paws) faster and I skip lines, I need to find the sweet spot but it's tough. this is 21 x 22 Poplar, .007 Pixel Resolution, 56 IPM, 25%, Horizontal
Thanks
Jerry

Re: Memorial

Posted: Sun Dec 27, 2015 11:57 am
by Picengravertoo
Hi Jerry,

Very nice. :cool)

Have you tried reducing your Max depth of cut some so the large z axis moves are less?

Jeff

Re: Memorial

Posted: Mon Dec 28, 2015 7:52 am
by Picengraver
Well done, Jerry.

Have you tried increasing your Z acceleration setting some?

HNY,
John

Re: Memorial

Posted: Mon Dec 28, 2015 8:30 am
by Picengravertoo
John,

It's about time you changed your Avatar. ;-D

Jeff

Re: Memorial

Posted: Mon Dec 28, 2015 9:20 am
by Honk
Hi All
I need to take the time to see where I should set all the Axis. The stepper drivers all new (the ones Jeff suggested) and they are an improvement from the old ones. I need to find out where the Acceleration and Velocity should be set. I re-set them and if it loses steps (a few hours later) I just set it back where they were and get lazy. I know, DUMB!!
I Can play with the Max Depth a little (and will) as I am usually around 5/8 in. in depth and have about 1/4 in. in focus so there is room to try.
Thanks for the help
Jerry