Page 1 of 1

EmBlaser Goes Loco

Posted: Fri Jun 03, 2016 3:25 pm
by Picengravertoo
PicEngrave Pro 5, 3W EmBlaser, 130IPM, 25% FRC, Min 10, Max 255, .006" Pixel Resolution, Skip White and engraved 45D Left on Brown/Gray Chipboard. The engraved size is 10X5 and 1,035,163 lines of gcode was streamed with PicSender & this RCA Cambio Win10 Tablet.

http://www.amazon.com/RCA-Cambio-Detach ... io+10.1%22

http://www.walmart.com/ip/RCA-Cambio-10 ... 0/45804385

It took a total of 2:17:38 in time to engrave.

Loco.jpg
Loco.jpg (471.75 KiB) Viewed 4351 times

Re: EmBlaser Goes Loco

Posted: Sat Jun 04, 2016 6:54 am
by Picengraver
Nicely done Jeff. Guess I need to get some of that chipboard.

Re: EmBlaser Goes Loco

Posted: Sat Jun 04, 2016 7:52 am
by Picengravertoo
Thanks John. What is interesting about the Brown ChipBoard, the lower laser power bleaches the Brown lighter which expands the shades even more. I like it better then the Brown/Gray.

Re: EmBlaser Goes Loco

Posted: Sat Jun 04, 2016 12:08 pm
by Picengravertoo
On Brown Chipboard.

Loco2.jpg
Loco2.jpg (445.57 KiB) Viewed 4331 times

Re: EmBlaser Goes Loco

Posted: Sat Jun 04, 2016 11:28 pm
by Picengraver
:Bravo!