Page 1 of 1

PicSender & MultiMode grbl 1.0c

Posted: Wed Oct 19, 2016 9:42 am
by Picengravertoo
Laser engraved on 12"X12"X.125" piece of Birch Ply with our 6W Shapeoko 2 using Larry's MultiMode grbl 1.0c that can be downloaded from here..

https://discuss.inventables.com/t/xcarv ... -fix/28943

The 1,237,164 lines of gcode was generated with PicEngrave Pro 5 and streamed with PicSender. After the engraving was finished, I used the Manual Move menu in PicSender to cut it out with the laser.

plane.jpg
plane.jpg (469.54 KiB) Viewed 2907 times

Re: PicSender & MultiMode grbl 1.0c

Posted: Thu Oct 20, 2016 8:45 pm
by Picengraver
One of your best efforts to date.

Re: PicSender & MultiMode grbl 1.0c

Posted: Fri Oct 21, 2016 10:34 am
by Picengravertoo
Thanks John. None of this would be possible without you.