Page 1 of 1

PEP6 "Program not responding"

Posted: Sat Feb 10, 2018 12:30 pm
by George M
I have had PicLaser for about a year. I have been thinking of upgrading to PEP6. I downloaded the program and installed it. However whenever it tries to generate / save the code it will produce a spinning wheel for a couple of minutes and then stop with the above error.

I'm running Win10 and using 3D Printer Laser PWM settings. I do have the JTech 2.8 laser.

Any ideas?

George

Re: PEP6 "Program not responding"

Posted: Sat Feb 10, 2018 12:56 pm
by George M
An Update.

It will generate code for Mach3 or Analog, but not for the 3D Printer laser.

Re: PEP6 "Program not responding"

Posted: Sat Feb 10, 2018 8:43 pm
by George M
I also tried the program on my Win 7 computer. Same result. It errors out when trying to save the gcode.
Here are the settings I am trying to use.


PEP6 settings.jpg
PEP6 settings.jpg (159.9 KiB) Viewed 3946 times

Re: PEP6 "Program not responding"

Posted: Sun Feb 11, 2018 4:16 am
by Picengraver
Thank you George for reporting this. There is a problem in the demo version. I have just verified that 3D Laser does work correctly in the registered version. I will fix the demo version as soon as time permits.
John