Picengravertoo wrote:If your saying the Chinese driver turns on the laser with 0v and off with 5v, our PicLaser & PicEngrave Pro 5 can generate gcode to work with it and grbl. The Min/Max values would have to be reversed and the image would need to be Dithered to 1bit B&W.
No it did not work that way either. I will be wondering what his answer will be this time. Last time it was to tell me it was a Driver board and it needed to be connected to a signal in addition to 12 volts. Its on at 0 volts and its on at 5 volts, so go figure. Like most Chinese I have purchased from its always the buyer who is dumb. Last time I ordered a stepper motor for a project, the wired connector instead of 4 wire was 3 wire. I had to send him a picture so he could be sure!