Puzzle and Clock

[Honk]

raccoon4forum.jpg (99.7 KiB) Viewed 5193 times

My new 6W doing better. I tried the 6 W on the cut, it worked but it left a dark line on the cut. I tried the 40 w CO2 It was about the same. I ended up using the router, It was better and a lot faster. I did like John suggested and cut from both sides, I cut the front not as deep as the mirrored back. They all broke off good but one piece needed repair. The next one I am going to cut it first and than laser the picture, I think the white space will be less (I Think ???). Here is a link to my new clock (I just got it going)
Thanks for the look]
Jerry

[Picengravertoo]

Very nice engraving/puzzle Jerry and your clock is ingenious!

Thanks for sharing.
Jeff

[Picengraver]

Nice, Jerry. Is the clock your own design?
John

[Honk]

Thank you both
Yes and it keeps time right with the clock on the stove. It was running a little fast when I first started it up and that night I had to shut it down because it was already tomorrow in the shop.
Jerry