Well it appears that my BoB was messed up. Spoke with Jay at J-Tech and we went through a detailed troubleshooting session and really didn't come up with a definitive answer. So I ordered a new BoB and Jay sent me a new DAC. Got the Bob and DAC on the same day. So I installed the new BoB and after messing around with all the settings, it still wasn't working as I had all the settings pretty much the same as before. Until I was testing the output voltages and noticed the Step voltage was 4.9V, where on the other BoB the voltage was non existent or less than 1V. Changed the steplow check mark on Mach3 and viola.
So anyway I have modulation now. And ran the same file as at the beginning of this post. I think Im running a little fast at a feed rate of 90ipm. the pixels are at (.01). What do you think?
- Screen Shot 2016-12-20 at 5.50.12 PM.jpg (265.5 KiB) Viewed 7761 times