I'm having a small issue using picsender (2.7.6). I have a relatively small nc file that engraves in approx ten minutes. Slightly more than half way thru the project the laser engraver (emblaser) pauses for a few seconds with the laser staying @ full power resulting in a noticeable extra burn in the middle of the engraving.
The machine has all power management and screen savers turned off, and I was next to the computer when this happened - there did not appear to be any indication for the reason for the pause. Perhaps the emblaser controller had run out of memory and had to load the next segment of the nc file. In any case: has anyone run across similar issues? Any suggestions for a remedy? Thanks in advance for any replies / assistance.