New machine problems
Forum rules
Be Kind to other's.
No Cussing or Swearing.
Don't post anything Illegal or Obscene.
Image attachment size limit is 500 KiB.
Be Kind to other's.
No Cussing or Swearing.
Don't post anything Illegal or Obscene.
Image attachment size limit is 500 KiB.
New machine problems
I just finished the installation of X-Carve no.2 ..It appears to work just fine using Easel. When I try to use PicSender it wants to use Com4..X-Carve no.1 uses Com3.. I do not understand why the change. I am able to jog the machine, but not able to execute 'Home' . I get a GRBL error 5. Help
-
Picengraver
- Full Access Moderator
- Posts: 338
- Joined: Tue Dec 23, 2014 5:40 pm
- Contact:
Re: New machine problems
I don't use Easel, so I can not explain why it uses the port it does. But PicSender only uses the com port numbers as assigned by Windows.
The error you get when trying to home can be found on PicSender's GRBL screen (click the GRBL button). Error 5 is 'Homing cycle is not enabled via settings". To enable homing, set grbl's $22=1 (see page 19 of PicSender's tutorial - click 'Help' then click 'Tutorial').
John
The error you get when trying to home can be found on PicSender's GRBL screen (click the GRBL button). Error 5 is 'Homing cycle is not enabled via settings". To enable homing, set grbl's $22=1 (see page 19 of PicSender's tutorial - click 'Help' then click 'Tutorial').
John
Who is online
Users browsing this forum: No registered users and 2 guests