Just new to Pic Sender. Came over from UGS.
I've been using Pic Sender for a few days now with no issues. Loving it.
But today it is doing something strange.
If there is no file loaded, i can have it probe and set Z axis to 0
if i have a file loaded and try to probe. it will go down to the plate but istead of rising as above, it tries to kepp going?
ive checked the setings
I've rebooted the program and laptop.
Does anyone know know why?
How can i stop this?
I have G91 z=15mm but when i hit Z+ or Z- it goes all the way till it hits the limit or i hit the red button.
I should say i'm using XCarve and programing in VCarve Pro
UPDATE: I found that the issues only occur after using the Quick Codes i've set up.