John
- Mr Bean.jpg (299.62 KiB) Viewed 10040 times
PicEngrave Pro Spindle Photo Engraving
Forum rules
Be Kind to other's.
No Cussing or Swearing.
Don't post anything Illegal or Obscene.
Image attachment size limit is 500 KiB.
Be Kind to other's.
No Cussing or Swearing.
Don't post anything Illegal or Obscene.
Image attachment size limit is 500 KiB.
-
Picengraver
- Full Access Moderator
- Posts: 401
- Joined: Tue Dec 23, 2014 5:40 pm
- Contact:
PicEngrave Pro Spindle Photo Engraving
I engraved this a while back using PicEngrave Pro generated gcode on poplar. I used a 1/8 inch, 30° angle, single-edged, vbit. I don't recall the other settings, but I believe the maximum depth of cut was probably about 0.040 inches.
John
John
Who is online
Users browsing this forum: No registered users and 9 guests