Spindle engraved in bass wood.
3.8 in.w x 5.0 in. h
Max. Depth - .035 inches
PicEngrave Pro 5
1/8 in. dia./30° V bit
PR - .007 inches
Engraving Angle - Horiz 2x
Shapeoko 2 - DeWalt DWP611 spindle
About 1 hour 15 min to carve.
Finish was experimental, and not as good as I had hoped. Final sealing with spray shellac.
Hard to photograph, so please excuse the "sparkle" effect from flash.
John
PicEngrave Pro 5 Spindle Engraving
Forum rules
Be Kind to other's.
No Cussing or Swearing.
Don't post anything Illegal or Obscene.
Image attachment size limit is 500 KiB.
Be Kind to other's.
No Cussing or Swearing.
Don't post anything Illegal or Obscene.
Image attachment size limit is 500 KiB.
-
Picengraver
- Full Access Moderator
- Posts: 401
- Joined: Tue Dec 23, 2014 5:40 pm
- Contact:
PicEngrave Pro 5 Spindle Engraving
- Attachments
-
- Mr Bean 3 forum.jpg (396.58 KiB) Viewed 8633 times
Who is online
Users browsing this forum: No registered users and 5 guests